Step 6 - Ethernet Setup

Step 6 - Ethernet Setup

Change adapter properties

1. Press Win + R type ncpa.cpl and click Ok

   
2. Right-Click your Ethernet and click on Properties

3. Configure it as shown here <-

   (Scroll down and disable the Rest)

   
4. Click Configure

   
5. Switch to Advanced and configure the following properties:

   

Advanced EEE - Disabled

ARP Offload - Disabled

Flow Control - Disabled

IPv4 Checksum Offload - Disabled

Large Send offload v2 (IPv6) - Disabled

Network Address - Not Present

TCP Checksum Offload (IPv6 ) - Disabled

UDP Checksum Offload (IPv6 ) - Disabled

Restart your pc.

1. Open CMD as ADMINSTRATOR (and type those commands in delay of 30s between each other.) ipconfig /flushdns ipconfig /registerdns ipconfig /release ipconfig /renew netsh Winsock reset Now, Restart your pc.

   
2. Open CMD as ADMISTRATOR AGAIN (and type those commands in delay of 5s) arp -d nets interface IP delete Arcache Now, Restart your pc.

Router Restart

1. Search on google: my IP.

2. Go to the first when site and save your IP address.

3. Check what is your IP, screenshot it. Disconnect your router (Wi-Fi) for 6 minutes and connect it back. Compare the IP serials, + use VPN (WINDSCRIBE) for 14 days (THE ONE BELOW ONLY).

4. Restart PC, check if your IP changed.

You Should see here ONLY ethernet. Verify its verified and you did all at

VPN

IF YOU COMPLETED AMD RAID (Raidable)/ INTEL RAID (Raid0) YOU DO NOT NEED VPN

1. Download Windscribe

2. Enter Your Username + Password you got after buying the Vpn in our website:

   
3. Login And Press : Wire Guard

   
4. Select: Stealth

   
5. Final Result:

   

NOTE: You will have to use the VPN for 14 days. after 14 days, you can turn it off and play just as regular.